How To Build A Poker Table

instructions

To build a rectangle poker table – or rather, a table top – that can be used when it doesn’t need to follow the instructions below.

The materials required include MDF (Medium Density Fiberboard), ply, wood screws, Wattyl Interior Stain and Wattyl Estapol Gloss (Clear Lacquer) for an exposed wooden “beer rail,” staples, adhesive spray, PVA wood glue (from the hardware store) ; white vinyl, length blue felt (from the fabric store), foam, and EVA foam (from the foam supplier). The total cost of materials would be about $ 210. The tools required include a jigsaw (drill for shaping wood), one-time use, for pilot hole for jigsaw blades, orbital sanders or sandpaper (to correct the jigsaw-handling inadequacy), one for every 1,000 staples. , and a helper 우리카지노.

Start with a top sheet of plywood if a “beer rail” is required; otherwise, use two sheets of MDF to mark out and cut the shape of the table or table top (use an electric kitchen knife, $ 20). Begin with a 1,200mm-wide sheet – to come in 600mm from the side and ends – to find the midpoint of the oval arc. Screw in a broom handles there and draw against the firm edge. Cut the curves off and place the top “template” over the bottom sheet of MDF. Trace around the table to make the pieces fit evenly. Now, the four corners off the bottom sheet, leaving a 700mm wide felt-covered playing area. Move it to the side, and cut it to the jigsaw to separate the padded rail section.

Stain the ply and spray some foam to the back of the EVA foam and to the plywood. Trim the edges off (use Stanley knife). Lay out the felt, flip over the board, and staple it on tight (use an electric stapler), cut off any excess felt. Now, the two inches of foam over-cut one inch to make a rounded edge off the outside edge. The foam is down with PVA glue wood to the padded rail section of wood. Sand before and after the first coat of lacquer. Staple on either side of the foam and seal the ends. Turn over the railroad, apply it to the main table section, and staple it. Pull the table and the helper to staple from the bottom. Drop (or screw) the felt section straight into the middle. The poker table is complete.

Leave a Reply

Your email address will not be published. Required fields are marked *